Nevada DMV CDL General Knowledge Practice Test 6
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. You are driving past a park where children are playing close to the curb. What is the correct assumption?
Show answer
Answer A: A child may run into the street without looking
Children act on impulse and do not judge traffic well, so a driver has to expect one to enter the road and slow down in advance.
-
2. A company mechanic serviced your truck this morning and signed the work order. Do you still have to inspect the vehicle?
Show answer
Answer B: Yes, the driver is still responsible for being satisfied the vehicle is safe
Shop work does not transfer the duty; the driver who takes the vehicle out remains responsible for being satisfied it is in safe operating condition.
-
3. After coupling, where should the fifth wheel release handle be?
Show answer
Answer A: In the locked position with the safety latch in place
The handle must be pushed in and latched, because a handle left out means the jaws can open and release the trailer while you are driving.
-
4. Two tires in a dual set have noticeably different diameters. Why is that a problem?
Show answer
Answer C: The larger tire carries more than its share of the load and can be overloaded
The taller tire touches the road first and takes most of the weight, so it runs overloaded and hot while the smaller one does little work.
-
5. During the vehicle overview, what should the driver look for on the ground under the vehicle?
Show answer
Answer B: Fresh puddles of oil, coolant, grease or fuel
New stains on the ground are the earliest sign of a leak, so the overview includes a look underneath before anything is opened or started.
-
6. What should you do before backing into a space you have not used before?
Show answer
Answer A: Get out and walk around to check the path, the clearance and any obstacles
Walking the area first reveals low obstructions, soft ground and objects that never appear in the mirrors.
-
7. Which vehicle is most likely to be pushed around by a strong crosswind?
Show answer
Answer B: An empty van trailer
A large flat side with very little weight behind it gives the wind the most surface and the least resistance, which is the empty van trailer.
-
8. Who must sign a driver vehicle inspection report?
Show answer
Answer D: The driver who prepared it
The report is the driver statement about the condition of the vehicle at the end of the day, so the driver signs it.
-
9. What is the purpose of the header board, or headache rack, that you inspect behind the cab?
Show answer
Answer A: It protects the driver from cargo that shifts forward during a hard stop
In a hard stop the load keeps moving forward, and the header board is the barrier between that load and the back of the cab.
-
10. An unblocked crate 4 feet long and weighing 900 pounds needs at least how many tiedowns?
Show answer
Answer D: One
An article 5 feet or less in length and 1,100 pounds or less in weight is covered by a minimum of one tiedown.
-
11. Why does the commercial driver manual tell you to look far down the road instead of only at the vehicle ahead?
Show answer
Answer D: So you can adjust smoothly instead of braking hard at the last moment
A heavy vehicle cannot react quickly, so early information lets you slow gradually rather than make a sudden stop or swerve.
-
12. Which road users are hardest to see at night?
Show answer
Answer C: Pedestrians and cyclists in dark clothing
People on foot or on a bicycle carry no lights of their own in many cases, so they appear only when the headlights reach them.
-
13. During uncoupling, when may the fifth wheel locking lever be released?
Show answer
Answer D: Only after the landing gear is down and taking the weight of the trailer
The landing gear has to be supporting the trailer before the lock is released; otherwise the trailer nose can drop as soon as the tractor pulls out.
-
14. Dry bulk tanks call for extra caution mainly because of what?
Show answer
Answer C: A high center of gravity combined with a load that can shift
Dry bulk loads ride high and can move inside the tank, which makes the vehicle easier to tip in a curve.
-
15. At 55 mph, about how far does a vehicle travel during a typical 3/4 second perception time plus 3/4 second reaction time, before the brakes even begin to work?
Show answer
Answer C: About 120 feet
Each 3/4 second at 55 mph covers about 60 feet, so perception and reaction together use up roughly 120 feet before braking starts.
-
16. You drop your phone on the floor of the cab while driving. What do federal rules require?
Show answer
Answer A: Leave it, because reaching for it while driving is banned
Federal rules forbid reaching for a mobile device in any way that takes the driver out of a seated, belted driving position.
-
17. An automatic transmission is left in its normal drive position as the vehicle rolls down a long grade. What does it tend to do?
Show answer
Answer A: Shift up as road speed rises, so engine braking falls away
An automatic left in drive keeps upshifting as speed builds, which is the opposite of what you want on a grade; that is why the driver must select a low range.
-
18. Which components on a typical engine are driven by belts that must be checked for wear and tension?
Show answer
Answer D: The alternator, the water pump and, on many vehicles, the air compressor
Belts drive accessories such as the alternator, the water pump and the air compressor, so one failed belt can take out charging, cooling or air supply.
-
19. How are the extra gears of a multi-speed rear axle or auxiliary transmission usually controlled?
Show answer
Answer D: With a selector knob or switch on the gearshift lever of the main transmission
A range selector on the shift lever lets the driver choose the extra gear range while shifting the main transmission.
-
20. Why does a load of hanging meat in a refrigerated trailer require special care in curves?
Show answer
Answer D: The meat swings and has a high center of gravity, which makes the trailer unstable
Hanging meat is heavy, sits high and swings, so the trailer can tip in a curve or on a ramp taken at normal speed.
-
21. What are you checking when you look at the batteries during the engine compartment inspection?
Show answer
Answer D: That they are securely mounted, the connections are tight and free of corrosion, and the caps are in place
Loose or corroded batteries can fail or short out, so the mount, cables, terminals and vent caps are all part of the check.
-
22. How long must a motor carrier keep a driver vehicle inspection report and the certification of repairs?
Show answer
Answer B: Three months
The original report and the certifications attached to it are kept on file for three months from the date the report was prepared.
-
23. What does it mean to overdrive your headlights at night?
Show answer
Answer D: Driving so fast that you cannot stop within the distance lit by your headlights
You must be able to stop inside the distance you can see; at night that distance is limited by the headlights, so speed must be lowered to match.
-
24. Why must a bent, cracked or badly seated lock ring be reported?
Show answer
Answer D: It can come off under pressure and let the tire and rim separate violently
The lock ring holds the assembly together against the full pressure of the tire, so a damaged ring can release with enough force to kill.
-
25. You are loading a flatbed that has no sides or bulkheads. How must the cargo be held?
Show answer
Answer D: By tiedowns, blocking or bracing, since there are no walls to keep it from shifting or falling off
Open decks depend entirely on securement devices; every article must be tied down or otherwise immobilized so it cannot move, spill or fall.
-
26. You are about to back across a quiet street into a driveway. Which of these is good practice before you start to move?
Show answer
Answer B: Turn on the four-way flashers and sound the horn to alert anyone nearby
Warning other road users and pedestrians before a reverse maneuver gives them the chance to stop or move clear before the vehicle starts back.
-
27. Why does a cracked frame rail or cross member make a vehicle unsafe?
Show answer
Answer B: The frame carries the whole load, and a crack can spread until the structure fails
The frame is the backbone that supports the body, the load and the running gear, so a crack in it is a structural failure that grows with every mile.
-
28. Which factors determine a safe speed for a long, steep downgrade?
Show answer
Answer C: The steepness and length of the grade, the weight of the vehicle and cargo, and the road and weather conditions
Gravity, weight and traction all decide how fast a heavy vehicle can safely descend, which is why signs often post lower speeds for trucks on grades.
-
29. Your speedometer stops working during the pre-trip check. How should it be treated?
Show answer
Answer D: As a defect, because the driver cannot judge and control speed without it
A working speedometer is required equipment, because judging speed by feel in a heavy vehicle is unreliable and speed governs stopping distance.
-
30. Why should a retarder be switched off when the road is wet, icy or snowy?
Show answer
Answer C: It can make the drive wheels skid when traction is poor
A retarder slows the drive wheels only, and on a slippery surface that braking force can break their traction and start a skid.
-
31. When should the horn of a commercial vehicle be used?
Show answer
Answer C: Only when it is needed to avoid a crash
An air horn is loud enough to startle other road users, so it is a warning device rather than a way to comment on other drivers.
-
32. Why is a sudden, sharp lane change dangerous in a loaded heavy vehicle?
Show answer
Answer D: The vehicle can lean far enough to roll over, especially when the load sits high
A quick swerve throws the weight of a tall, heavy load sideways, and a rollover can begin before the tires ever slide.
-
33. You have chosen 40 miles per hour as your safe speed for a downgrade. How should the brakes be used?
Show answer
Answer A: Brake firmly to about 35, release, and repeat at 40
Proper technique is firm application to about 5 miles per hour below the safe speed, then full release so the brakes cool before the next application.
-
34. A car ahead of you keeps drifting within its lane and moving unevenly. What should you assume?
Show answer
Answer C: The driver may be distracted, lost or impaired
Unsteady lane keeping is a classic clue to a driver who is not in full control, so the safe response is to keep back and give plenty of room.
-
35. What does safe practice require of a commercial driver who wants to eat, drink or read a delivery note?
Show answer
Answer B: Handle it before or after driving, not while moving
Anything that takes hands, eyes or attention away from the task belongs outside the driving time, not inside it.
-
36. How do you get more engine braking from an automatic transmission on a downgrade?
Show answer
Answer B: Select a lower range before starting down
Locking the transmission into a lower range keeps engine speed high enough to hold the vehicle back and spares the service brakes.
-
37. What does the federal bridge formula do?
Show answer
Answer C: It reduces the weight allowed on a group of axles as those axles get closer together
Axles bunched together concentrate the load on a short span of a bridge, so the formula lowers the allowable weight as the spacing shrinks.
-
38. On packed snow, how much should a commercial driver reduce speed?
Show answer
Answer D: By about one half or more
Packed snow costs far more traction than rain, so speed should be cut by half or more.
-
39. Under the federal air brake standard, the low air pressure warning must come on before reservoir pressure drops below what level?
Show answer
Answer A: Before pressure falls below 60 psi
Federal Motor Vehicle Safety Standard 121 requires the warning to operate while service reservoir pressure is still above 60 psi, which leaves enough air to bring the vehicle to a normal stop.
-
40. Why should you never shift gears while crossing railroad tracks?
Show answer
Answer A: You could miss the gear or stall and be stuck on the tracks
A stalled or coasting vehicle on the tracks has no way to clear quickly, so choose the gear before the crossing and do not shift until you are across.
-
41. Part of your load stands high enough to hide a rear lamp or a reflector. What must be done?
Show answer
Answer B: The load must be moved or extra lamps fitted so the required lights can be seen
Required lamps and reflectors must remain visible; if the cargo blocks them, the load is rearranged or additional lamps are fitted so the vehicle can still be seen.
-
42. As a long vehicle goes around a corner, how do the rear wheels travel compared with the front wheels?
Show answer
Answer A: They follow a tighter path, closer to the inside of the turn
The rear wheels off-track toward the inside of the turn, and the longer the vehicle the bigger the difference, which is why the front must swing wide enough to keep the rear off the curb.
-
43. Cargo carried inside the cab must never do which of these?
Show answer
Answer C: Block the driver view, restrict arm or leg movement, or block an emergency exit
Anything inside the cab must leave the driver a clear view, free movement of the arms and legs, and an unobstructed way out of the vehicle.
-
44. At highway speed, looking 12 to 15 seconds ahead means looking about how far down the road?
Show answer
Answer B: About a quarter of a mile
Twelve to fifteen seconds of travel is roughly a quarter of a mile at highway speed, while the same amount of time is about one block in slow city traffic.
-
45. What should you look for on the electrical wiring in the engine compartment?
Show answer
Answer A: Worn, frayed or cracked insulation and loose or corroded connections
Damaged insulation can short a circuit against the frame or engine, which can kill a lamp you depend on or start a fire.
-
46. A tire blows out at highway speed. What should the driver do first?
Show answer
Answer C: Hold the steering wheel firmly, stay off the brake and let the vehicle slow down
Braking while a tire is gone can pull the vehicle out of line, so the driver keeps it straight and lets speed fall before easing off the road.
-
47. When should a lower gear be selected for a long downgrade?
Show answer
Answer D: Before you start down the hill
The gear is chosen at the top, while speed is still low, because a heavy vehicle already rolling fast may not go into a lower gear at all.
-
48. A strap is a little too long, so a driver ties a knot in it to take up the slack. Is that acceptable?
Show answer
Answer C: No, tiedowns must not contain knots
A knot destroys the rated strength of a tiedown, so the rules do not allow knotted securement devices; the excess is taken up by the winch or ratchet instead.
-
49. Which lights should be used in fog, by day or by night?
Show answer
Answer A: Low beams and fog lights, together with the four-way flashers
High beam light bounces back off the water droplets and makes seeing worse, while low beams, fog lights and flashers help you see and help others see you.
-
50. Why must exhaust components be checked for contact with other parts of the vehicle?
Show answer
Answer B: Hot exhaust parts touching fuel lines, tires or wiring can start a fire
Exhaust pipes run hot enough to ignite fuel and melt insulation, so they must be kept clear of the fuel system, the tires and the electrical harness.